Kyocera KM-4230

3-1-47
2A3/4
3-1-9 Installing the MMD host monitoring system device
(optional for 120 V specifications only)
<Procedure>
1. Remove the two screws holding the signal cable cover and then the cover.
Screws
Signal cable cover
Figure 3-1-59
2. Pull the 10-pin connector out of the machine, remove the jumper and insert the
connector into the 10-pin connector of the signal cable.
Secure the signal cable using the two screws removed in step 1.
Screws
10-pin connector
10-pin connector
Signal cable
Jumper
Figure 3-1-60