2A3/4
3-3-14
( 3 ) Replacing the upper and lower paper width switches (Inch models only)
Replace the upper and lower paper width switches as follows.
Caution: After replacing a paper width switch, be sure to perform (5) Adjusting the
position of the rack adjuster.
<Procedure>
1. Open the drawer.
2. Remove the four screws and take the drawer out of the machine.
Screws
Screws
Drawer
Figure 3-3-17
3. Remove the two screws and 8-pin socket from the rear of the drawer.
4. Detach the 8-pin paper width switch connector from the 8-pin socket.
5. Remove the three screws holding the rack adjuster.
6. While raising the drawer lift in the direction of the arrow, remove the rack adjuster.
Drawer lift
8-pin socket
8-pin connector
Rack adjuster
Screws
Screws
Figure 3-3-18 Detaching the rack adjuster
To Next Page
Loading...
