2A3/4
3-3-19
(6-2) Adjusting the center line of image printing
Make the following adjustment if there is a regular error between the center lines of the
copy image and original when paper is fed from the drawer.
U034
U404
(P.3-3-100)
U067
(P.3-3-38)
U072
(P.3-3-97)
U403
(P.3-3-40)
U 402
(P.3-3-20)
Caution:
• Perform (5) Adjusting the position of rack adjuster before and after this adjustment.
• Check the copy image after the adjustment. If the image is still incorrect, perform the
above adjustments in maintenance mode.
<Procedure>
Yes
No
Start
Enter maintenance mode.
Enter "034" using the numeric keys.
Press the print key.
Press the interrupt key.
Press the print key to make
a test copy.
Is the image correct?
Press the print key.
The new setting is stored.
Press the stop/clear key to exit
maintenance mode.
End
Select "LSUOUT DATA."
For output example 1, decrease
the value using the Down key.
For output example 2, increase
the value using the Up key.
Setting range: –30.0 - +30.0
Changing the value by 1 moves the
center line by 0.5 mm.
Reference: 0
Figure 3-3-25
Correct image Output
example 1
Output
example 2
Center line of printing
To Next Page
Loading...
