2A3/4
3-3-92
6. Remove the two screws holding the DF original feed lower guide and the two
screws holding the DF original feed upper guide.
7. Loosen the other two screws on the DF original feed lower guide.
8. While lifting the DF original feed upper guide and pressing the original set switch
actuator, remove the DF original feed lower guide.
DF original feed upper guide
DF original
feed lower
guide
Original set switch
actuator
Screws
(To be loosened only)
Screws
Screw
Screw
Figure 3-3-109
9. Detach the original set switch 3-pin connector.
10. Remove the two screws holding the separation pulley retainer.
Separation pulley retainer
3-pin connectors
Figure 3-3-110
To Next Page
Loading...
