2A3/4
3-3-91
( 2 ) Detaching and refitting the DF separation pulley
Clean or replace the DF separation pulley as follows.
<Procedure>
1. Open the DF reversing cover.
2. Remove the two screws holding the upper original feed section cover and then the
cover.
3. Remove the two screws holding the DF rear cover.
4. Remove the screw holding the fulcrum pin and then the pin.
5. Detach the 6-pin connector and remove the original table.
Fulcrum pin
6-pin connectors
Original table
Screw
Figure 3-3-108
To Next Page
Loading...
