2A3/4
3-3-99
(6-2) Adjusting the DF trailing edge registration
<Procedure>
Enter maintenance mode.
Enter "071" using the numeric
keys and press the print key.
Yes
No
Start
End
• For copy example,
decrease the value using
the Down key.
Press the interrupt key.
Exit maintenance mode.
Press the stop/clear key.
Place an original on the DF
and make a test copy.
Is the image correct?
Setting range: –32 - +32
Reference: 0
Changing the value by 1 moves
the copy image by 0.19 mm.
Press the print key.
The new setting is stored.
To adjust the DF trailing
edge registration, select
"TRAIL EDGE ADJ."
Figure 3-3-117
Original Copy
example
To Next Page
Loading...
