2A3/4
3-3-100
( 7 ) Adjusting the margins for scanning the original from the DF
Perform the following adjustment if margins are not correct.
U402
(P.3-3-20)
U404
U403
(P.3-3-40)
Caution: Before making the following adjustment, ensure that the above adjustments
have been made in maintenance mode.
<Procedure>
Change the setting.
• Increasing the value using the
Up key makes the margin
wider.
• Decreasing the value using the
Down key makes the margin
narrower.
Touch panel display
DF A MARGIN: DF left margin
DF B MARGIN: DF leading edge margin
DF C MARGIN: DF right margin
DF D MARGIN: DF trailing edge margin
Yes
No
Start
Enter maintenance mode.
Enter "404" using the numeric keys.
Press the print key.
Place an original on the
DF and make a test copy
Press the print key.
The new setting is stored.
Setting range (default)
DF left margin: 0 - +20 (2)
DF leading edge margin: 6 - +20 (6)
DF right margin: 0 - +20 (2)
DF trailing edge margin: 0 - +20 (6)
Changing the value by 1 moves
the margin by 0.5 mm for all.
Select the item to be adjusted
on the touch panel.
Are the margins correct?
AB
Press the interrupt key.
To Next Page
Loading...
