Kyocera KM-4230 - Page 500

2A3/4
3-6-55
Terminals (CN) Voltage Remarks
7-4 7-1 0/5 V DC LSU VD1 – signal, output
7-5 7-1 0/5 V DC LSU VD1 + signal, output
7-7 7-6 0/5 V DC LSU ENABLE signal, output
7-9 7-8 0/5 V DC LSU ADJUST2 signal, output
7-11 7-10 0/5 V DC LSU ADJUST1 signal, output
7-13 7-12 5 V DC 24 V DC supply for LSU, output
8-2 8-1 0/5 V DC LSU BD – signal, input
8-3 8-1 0/5 V DC LSU BD + signal, input
8-5 8-4 5 V DC 24 V DC supply for LSU, output
9-1 9-2 0/5 V DC (pulse) LSU clock pulse, output
9-3 9-2 0/5 V DC LSU START signal, output
9-4 9-2 0/5 V DC LSU READY signal, output
10-1 10-3 5 V DC 5 V DC supply for MPCB, input
10-2 10-3 0/5 V DC PSPCB SLEEP SIG, output
10-4 10-3 5 V DC 5 V DC supply for MPCB, input
10-5 10-3 0/5 V DC (pulse) Zero-cross signal, output
10-6 10-7 12 V DC 12 V DC supply for MPCB, input
11-1, -2, -3 11-1, -2 5 V DC 5 V DC supply for CCDPCB, output
11-4 11-1, -2 0/5 V DC CCD drive clock signal φ SHIFT –, output
11-5 11-1, -2 0/5 V DC CCD drive clock signal φ SHIFT +, output
11-6 11-1, -2 0/5 V DC CCD drive clock signal φ CLP –, output
11-7 11-1, -2 0/5 V DC CCD drive clock signal φ CLP +, output
11-8 11-1, -2 0/5 V DC CCD drive clock signal φ RS –, output
11-9 11-1, -2 0/5 V DC CCD drive clock signal φ RS +, output
11-10 11-1, -2 0/5 V DC CCD drive clock signal φ CLK –, output
11-11 11-1, -2 0/5 V DC CCD drive clock signal f CLK +, output
12-3 12-1, -2 12 V DC +12 V DC supply for CCDPCB, output
12-4 12-1, -2 CCD control signal VO_E –, input
12-5 12-1, -2 CCD control signal VO_E +, input
12-6 12-1, -2 CCD control signal VO_O –, input
12-7 12-1, -2 CCD control signal VO_O +, input
13A-1 5-16 0/5 V DC OSLED (red) on/off, output
13A-2 5-16 0/5 V DC OSLED (green) on/off, output
13A-3 5-16 0/5 V DC SBPSOL release signal, output
13A-4 5-16 0/5 V DC SBPSOL latch-on signal, output
13A-5 5-16 0/5 V DC OFCL on/off, output
13A-6 5-16 0/5 V DC EFSSOL on/off, output