2A3/4
1-3-46
MSW
PRY
H1
H2
CCM
DM
PCM
CL
DB REM
CFM1
PCFM
IFFM
PM
1 s
2 s
*3
Half speed
Primary stabilization fixing
temperature 175°C/347°F
Secondary stabilization fixing
temperature *1
Copying enabled
Aging end
Half speed
200 ms
270 ms
600 ms
50 ms
AB CD E F G H I
3 s
*2
Full speed
Charger wire cleaning
*1: 42 ppm: 180°C/356°F
52 ppm: 190°C/374°F
*2: 42 ppm: 60 s
52 ppm: 120 s
*3: 42 ppm: 116 s
52 ppm: 176 s
Timing chart 1-3-7 Fixing temperature control
A 2s after the main switch (MSW) is turned on, the power relay (PRY) and fixing
heater M (H1) turn on to heat the heat roller. The charger cleaning motor (CCM)
also turns on to clean the charger wire, and cooling fan motor 1 (CFM1) rotates at
half speed.
B 1 s after fixing heater M (H1) turns on, the polygon motor (PM) in the laser scanner
unit turns on.
Fixing temperature control
To Next Page
Loading...
