Kyocera KM-8030

2FB/2FC
1-6-21
8. Remove the stop ring and two bushes
from the MP paper feed pulley unit and pull
out the MP paper feed pulley shaft.
9. Remove the MP paper feed pulley and MP
paper feed pulley gear from the MP paper
feed pulley unit.
Figure 1-6-43
10. Remove the stop ring from the MP paper
feed pulley unit and pull out the MP forward-
ing pulley shaft.
11. Remove the MP forwarding pulley from the
MP paper feed pulley unit.
Figure 1-6-44
12. Clean or replace the MP paper feed pulley
and MP forwarding pulley, and then attach
the pulleys to the MP paper feed pulley unit.
* When replacing the MP paper feed pulley,
make sure that the one-way clutch of both
the pulley and the gear is placed toward the
rear side of the machine.
Figure 1-6-45
MP paper feed
pulley unit
MP paper
feed pulley
MP paper feed
pulley gear
MP paper feed
pulley shaft
Stop ring
Bush
Bush
Stop ring
MP forwarding
pulley shaft
MP forwarding pulley
MP paper feed
pulley unit
One-way
clutch
One-way
clutch