Kyocera KM-8030

2FB/2FC
1-6-85
8. Remove the stop ring and bush from the
original feed pulley unit and pull out the for-
warding pulley shaft.
9. Remove the DP forwarding pulley from the
original feed pulley unit.
Figure 1-6-167
10. Clean or replace the DP original feed belt
and DP forwarding pulley, and attach the
belt and pulley to the original feed pulley
unit.
* When replacing the DP original feed pulley,
make sure that the one-way clutch of the
pulley is placed toward the rear side of the
machine.
11. Insert the original feed belt unit to the origi-
nal feed pulley unit.
Figure 1-6-168
Detaching the DP separation roller
12. Insert the flat-blade screwdriver to the
inserted part of the separation guide and
remove the separation guide from the DP.
Figure 1-6-169
Original feed
pulley unit
Bush
DP forwarding pulley
Stop ring
Forwarding
pulley shaft
Bush
Forwarding
pulley shaft
Paper feed
pulley unit
Forwarding pu
Separation guide