Kyocera KM-8030 - Page 409

2FB/2FC-2.0
2-3-23
YC13
1DLP FAN F
REM
O 24 to 20.92/
20.92 to 0.5/
0.5 to 0 V DC
Developing fan motor 1/2: full speed/half speed/off
Connected
to the fan
motors drive
PWB, cool-
ing fan
motor 4,
duplex fan
motor and
humidity
sensor
2 PGND - - Power ground
3 COOL FAN1
REM
O 24 to 20.92/
20.92 to 0.5/
0.5 to 0 V DC
Cooling fan motor 1/2 and PWB fan motor 1/2:
full speed/half speed/off
4 PGND - - Power ground
5 COOL FAN4
REM
O 0/24 V DC Cooling fan motor 4: On/off
6 PGND - - Power ground
7 DUP FAN REM O 0/24 V DC Duplex fan motor: On/off
8 PGND - - Power ground
9 5V O 5 V DC 5 V DC power output
10 HUMID SENS
SIG
I Analog Humidity sensor humidity detection signal
11 SGND - - Signal ground
12 TEMP SENS
SIG
I Analog Humidity sensor temperature detection signal
YC14 1 DF SET I 0/5 V DC Document finisher set signal
Connected
to the
optional
document
finisher
2 OP SDO(DF) O 0/5 V DC
(pulse)
Document finisher serial communication signal
3 OP SDI(DF) I 0/5 V DC
(pulse)
Document finisher serial communication signal
4 OP SCLK(DF) O 0/5 V DC
(pulse)
Document finisher clock signal
5 DF SEL O 0/5 V DC Document finisher SEL signal
6 SI SEL - - Not used
7 DF RDY I 0/5 V DC Document finisher ready signal
8 SI RDY - - Not used
9 SG(DF) - - Signal ground
10 SG(DF) - - Signal ground
11 SG(DF) - - Signal ground
12 SG(DF) - - Signal ground
13 SG(DF) - - Signal ground
14 SG(DF) - - Signal ground
YC15 1 SG(SF) - - Signal ground
Connected
to the
optional side
feeder
2 SG(SF) - - Signal ground
3 SG(SF) - - Signal ground
4 SG(SF) - - Signal ground
5 SG(SF) - - Signal ground
6 SG(SF) - - Signal ground
7 SG(SF) - - Signal ground
8 SG(SF) - - Signal ground
9 STOP(SF) O 0/5 V DC Side feeder stop signal
10 OP SDO(SF) O 0/5 V DC
(pulse)
Side feeder serial communication signal
11 OP SDI(SF) I 0/5 V DC
(pulse)
Side feeder serial communication signal
12 SF RDY I 0/5 V DC Side feeder ready signal
13 SF SEL O 0/5 V DC Side feeder SEL signal
14 OP SCLK(SF) O 0/5 V DC
(pulse)
Side feeder clock signal
15 N.C - - Not used
Connector Pin No. Signal I/O Voltage Description