2FB/2FC
1-3-21
25. Refit the signal cable cover using the screw.
Pass the signal cable through a cut of the
signal cable cover as shown in the figure.
Figure 1-3-40
26. Remove the screw from the lower rear cover
of the machine.
27. Fit the clamp on non-covered part of the sig-
nal cable to secure the cable to the lower
rear cover with the M3 x 10 tap tight S
screw.
28. Plug the machine's power cable into a wall
outlet and turn the machine on from the
main power switch.
Figure 1-3-41
Signal cable cove
To Next Page
Loading...
