2FB/2FC
1-3-20
20. Insert the two nuts into the main tray.
21. Secure the main tray with two pins.
22. Install the sub tray by inserting it from above
into the hole on the finisher.
Figure 1-3-37
23. Remove the screw and then remove the sig-
nal cable cover.
Figure 1-3-38
24. Connect the signal cable to the connector of
the machine.
Figure 1-3-39
Main tray
Sub tray
Hole
Nuts
Pins
Signal cable cover
Signal cable
To Next Page
Loading...
