2FB/2FC
1-3-25
5. Attach the switch contact plate to the right
rear lower cover using the M4 x 12 flat-head
screw.
Figure 1-3-49
6. Pull out the fixing plate of the side feeder,
and insert it into the bottom of the machine's
right cover.
7. Open the right cover.
Figure 1-3-50
8. Install two M4 x 6 TP screws in the long
holes of the fixing plate.
Align the V-groove of the fixing plate with the
center of the guide of the machine.
Figure 1-3-51
M4 x 12 flat-head screw
Switch contact
plate
Right rear
lower cover
Fixing plate
Right cover
Fixing plate
Long hole
M4 x 6 TP screw
M4 x 6 TP screw
Center of the guide
Long hole
To Next Page
Loading...
