Kyocera KM-8030

2FB/2FC-3
1-4-3
Optical U060 Adjusting the scanner input properties 12/11
*1
U061 Checking the operation of the exposure lamps -
U063 Adjusting the shading position 0
*1
U064 Adjusting the CCD level 4
*1
U065 Adjusting the scanning magnification 0/0
*1
U066 Adjusting the scanner leading edge registration 10/0
*1
U067 Adjusting the optical axis (center line) 0/0
*1
U068 Adjusting the scanning position for originals from the DP 12
*1
U070 Adjusting the DP magnification 0/0/0
*1
U071 Adjusting the DP scanning timing
DP leading edge registration
DP trailing edge registration
0/0/0
*1
0/0
*1
U072 Adjusting the DP original center line
1 sided
2 sided front
Rotate copying
0
*1
0
*1
0
*1
U073 Checking the scanner operation -
U074 Adjusting the DP input light luminosity 0
*1
U076 Executing DP automatic adjustment -
U080 Adjusting exposure in eco print mode -5
*1
U087 Setting DP reading position modification operation 200
*1
U089 Outputting the MIP-PG pattern -
U092 Adjusting the scanner automatically -
U093 Adjusting the exposure density gradient
Text and photo mode
Text mode
Photo mode
0/0
*1
0/0
*1
0/0
*1
U099 Adjusting original size detection
ORIGINAL
LIGHT SOURCE
WAIT TIME
A4R AREA
72
*1
72
*1
150
*1
240
*1
High voltage U100 Adjusting the surface potential 82
*1
20
*1
0
*1
U101 Setting the other high voltages
Developing bias control voltage
Transfer control voltage
Reverse transfer control voltage
VPP setting value
117
*1
185 (80 cpm)/135 (60 cpm)
*1
215
*1
145
*1
U102 Setting the cleaning interval for the main charger 5
*1, *2
OFF
*1, *2
U110 Checking the drum count -
U111 Checking/clearing the drum drive time 0
*1, *2
U127 Checking/clearing the transfer belt count -
U129 Adjusting the transfer timing
Transfer charging output ON timing for plain paper
Transfer charging output OFF timing for plain paper
Transfer charging output ON timing for thin paper
Transfer charging output OFF timing for thin paper
Transfer charging output ON timing for thick paper
Transfer charging output OFF timing for thick paper
-1.5 (80 cpm)/-4.0 (60 cpm)
*1
0 (80 cpm)/13.0 (60 cpm)
*1
0 (80 cpm)/-2.5 (60 cpm)
*1
0 (80 cpm)/13.0 (60 cpm)
*1
-10.0
*1
0 (80 cpm)/13.0 (60 cpm)
*1
Developing U130 Initial setting for the developer 0
*1, *2
U132 Replenishing toner forcibly -
Section Item
No.
Content of maintenance item Initial setting*
*Initial setting for executing U020, *1: The item initialized for executing U020, *2: The item initialized for executing U021