2FB/2FC-3
1-4-4
Developing U135 Checking toner motor operation -
U137 Checking the toner level detection sensor -
U147 Setting for toner applying operation
6 (MODE6)
*1
U152 Setting developing motor mode ON
*1
U157 Checking the developing drive time -
U158 Checking the developing count -
Fuser and
cleaning
U161 Setting the fuser control temperature
Control temperature during copying
Primary stabilization fuser temperature
Secondary stabilization fuser temperature
Aging time after secondary stabilization
Control temperature adjustment in duplex copying
Time from power on to stabilization of fusing
Control temperature adjustment in duplex copying using A4/
Letter/B5 size paper
Control temperature adjustment when the fuser heater tem-
perature goes low
200 (80 cpm)/195 (60 cpm)
*1, *2
175 (120 V)/140 (220-240 V)
*1, *2
185
*1, *2
60
*1, *2
-10
*1
26
*1, *2
-15
*1, *2
0
*1
U162 Stabilizing fuser forcibly -
U163 Resetting the fuser problem data 0
*1, *2
U167 Checking/clearing the fuser count 0
*1, *2
U180 Checking the cleaning count -
U194 Setting the fuser web drive 30
*1
U196 Turning the fuser heater on -
U198 Setting the fuser phase control
OFF (120 V)/ON (220-240 V)
*1, *2
U199 Displaying fuser heater temperature 0
*1
Operation
panel/
Optional units
U200 Turning all LEDs on -
U201 Initializing the touch panel -
U202 Setting the KMAS host monitoring system -
U203 Operating the DP separately -
U204 Setting the presence or absence of a key card or key counter OFF
*1
U206 Setting the presence or absence of the coin vender OFF
*1, *2
U207 Checking the keys on the operation panel -
U208 Setting the paper size for the feeders 11 x 8.5 (inch)/A4 (metric)
*1, *2
U212 Setting the feeder lift operation SIDE
*1, *2
U234 Setting punch destination NOTHING
*1
U235 Setting output tray initialize mode HP ON
*1, *2
U237 Adjusting finisher stack quantity 0
*1, *2
U240 Checking the operation of the finisher -
U241 Checking the operation of the switches of the finisher -
U243 Checking the operation of the DP motors -
U244 Checking the operation of the DP switches -
U245 Checking messages -
U247 Setting the paper feed device -
Section Item
No.
Content of maintenance item Initial setting*
*Initial setting for executing U020, *1: The item initialized for executing U020, *2: The item initialized for executing U021
To Next Page
Loading...
