Kyocera TASKalfa 6052ci - Page 110

2-43
Installing and Setting up the Machine > Quick Setup Wizard
1
Display the screen.
[System Menu/Counter] key > [Quick Setup Wizard]
2
Select a function.
3
Configure the settings.
Start the wizard. Follow the instructions on the screen to configure settings.
Network Setup Configures network settings.
1. Network Network Selection
Wi-Fi
*7
DHCP
*8
IP Address
*9
Subnet Mask
*9
Default Gateway
*9
*1 This is displayed when the option of two FAX Kits has been installed.
*2 Inch version only.
*3 DRD reception mode is available for some countries.
*4 This setting does not appear in some regions.
*5 This function is displayed when the optional Job Separator (except 2552ci), Mailbox or 4,000-Sheet Finisher is
installed. When an Inner Finisher or a 1,000-Sheet Finisher is installed with the machine, this function is not
displayed.
*6 This function is displayed when [Weekly Timer] is set to [On].
*7 This function is displayed when [Network Selection] is set to [Wi-Fi].
*8 This function is displayed when [Network Selection] is set to [Wired Network].
*9 This function is displayed when [DHCP] is set to [Off].
NOTE
If the user authentication screen appears, enter your login user name and login password and select [Login].
The factory default login user name and login password are set as shown below.
NOTE
If you experience difficulty configuring the settings, refer to the following:
Help Screen (page 2-25)
Model Name Login User Name Login Password
2552ci 2500 2500
3252ci 3200 3200
4052ci 4000 4000
5052ci 5000 5000
6052ci 6000 6000