Kyocera TASKalfa 6052ci - Page 394

8-14
Setup and Registration (System Menu) > System Menu
Special Paper Action When printing on Prepunched, Preprint, and Letterhead, punch-holes might not be
aligned or the print direction might be upside-down depending on how originals are
set and the combination of copying functions. In such a case, select [Adjust Print
Direction] to adjust the print direction. When paper orientation is not important, select
[Speed Priority].
If [Adjust Print Direction] is selected, load paper according to the steps below.
Example: copying on Letterhead
Value: Adjust Print Direction, Speed Priority
Separator Paper Source Select the default paper source for separator sheets.
Value: Cassette 1 (to 5), Multi Purpose Tray
NOTE
[Cassette 3] to [Cassette 5] are displayed when the following optional paper feeder
is installed.
[Cassette 3]: When a paper feeder (500-sheet×2) or large capacity paper feeder
(1,500-sheet×2) is installed.
[Cassette 4]: When a paper feeder (500-sheet×2) or large capacity paper feeder
(1,500-sheet×2) is installed.
[Cassette 5]: When a side feeder (3,000-sheet) is installed.
Show Paper Setup
Message
Set whether to display the confirmation screen for the paper setting when a new
paper is set for each cassette.
Value: Off, On
NOTE
[Cassette 3] to [Cassette 5] are displayed when the following optional paper feeder
is installed.
[Cassette 3]: When a paper feeder (500-sheet×2) or large capacity paper feeder
(1,500-sheet×2) is installed.
[Cassette 4]: When a paper feeder (500-sheet×2) or large capacity paper feeder
(1,500-sheet×2) is installed.
[Cassette 5]: When a side feeder (3,000-sheet) is installed.
Cassette 1 to 5
Multi Purpose Tray
Item Description
Multi Purpose TrayCassetteFinishedPaperOriginal
Multi Purpose TrayCassetteFinishedPaperOriginal