2KN/2KP
1-5-23
17. Refit he MP separation pulley unit to the
lower MP unit.
Refit the stoppers to the center grooves.
Figure 1-5-47
18. Refit the MP paper feed pulley unit to the
upper MP unit.
19. Assemble the upper and lower MP units.
20. Refit the MP unit and MP tray.
* When refitting the MP unit, refit to insert the
shaft of the machine in coupling at rear side.
21. Refit the middle right cover, lower right rear
cover and developing fan cover.
Figure 1-5-48
22. When the MP paper feed pulley, MP for-
warding pulley or MP separation pulley is
replaced, perform maintenance mode U901
(clearing copy counts by paper feed loca-
tions) (see page 1-3-87).
Stopper
Center groove
Stopper
Center groove
Shaft
Coupling
To Next Page
Loading...
