Kyocera TASKalfa 620 - Maintenance Mode Item List

2KN/2KP
1-3-2
(2) Maintenance mode item list
Section
Item
No.
Content of maintenance item
Initial setting*
82 cpm 62 cpm
General U000 Printing out an own-status report -
U001 Exiting the maintenance mode -
U002 Setting the factory default data -
U003 Setting the service telephone number
***************
*1
U004 Setting the machine number -
U005 Copying without paper -
U018 Displaying the ROM checksum -
U019 Displaying the ROM version -
Initialization U020 Initializing all data -
U021 Memory initializing -
U022 Initializing backup memory -
U024 HDD formatting -
U026 Evacuation of backup data -
U027 Return of backup data -
Drive, paper
feed, paper
conveying
and cooling
systems
U030 Checking the operation of the motors -
U031 Checking sensors for paper conveying -
U033 Checking the operation of the solenoids -
U034 Adjusting the print start timing
Leading edge adjustment
Cassette
MP tray
Center line adjustment
2.1/0/2.1/0
*1
1.8
*1
-1.8/0
*1
0.8/0/0.8/0
*1
0
*1
0/0
*1
U035 Setting the printing area for folio paper
Length/Width
330/210
*1
U037 Checking the operation of the fan motors -
U051 Adjusting the amount of slack in the paper
Plain paper
Thick paper
3/3/3/3/3/3
*1
0/0/0/0/0/0
*1
U052 Adjusting duplex
-6
*1
U053 Setting the adjustment of the motor speed
Interlock setting
MAIN MOTOR
POLYGON MOTOR
Separate setting
Thick paper setting
Transfer setting
7/10/3/8/8
*1
-6
*1
7/10/3/8/-6/8
*1
5/5/0/0
*1
3
*1
7/10/3/8/8
*1
-6
*1
7/10/3/8/-6/8
*1
5/5/0/0
*1
3
*1
U054 Adjusting the vertocal conveying amount of slack in
the paper
0
*1
U059 Setting fan motor mode
OFF
*1
Optical U060 Adjusting the scanner input properties
12/11
*1
U061 Checking the operation of the exposure lamps -
U063 Adjusting the shading position
0
*1
U064 Adjusting the CCD level
4
*1
U065 Adjusting the scanning magnification
0/0
*1
U066 Adjusting the scanner leading edge registration
10/0
*1
U067 Adjusting the optical axis (center line)
0/0
*1
U068 Adjusting the scanning position for originals from the
DP
12
*1
U070 Adjusting the DP magnification
0/0/0
*1
*Initial setting for executing U020, *1: The item initialized for executing U020, *2: The item initialized for executing U021