2KN/2KP-1
1-5-24
(7) Pressure adjustment of MP separation pulley
Perform the following adjustment if no paper feed or multiple sheets of paper occurs for feeding from the MP tray.
Procedure
Figure 1-5-49
Refit two springs and then
refit the MP unit.
No
Yes
Press the start key and
make a test copy.
Start
End
Does multiple sheets of
paper feed occur?
Does no paper
feed occur?
No
Select the MP tray for
paper feeding.
Remove the MP unit (see page 1-5-17).
Reverse the MP unit and then remove
two springs.
Loosen two screws to move the position
of each front/back adjusting guide in the
direction of the white arrow ( ).
Fix each stopper at the center groove
of 3 grooves.
Remove the MP unit (see page 1-5-17).
Reverse the MP unit and then remove
two springs.
Loosen two screws to move the position
of each front/back adjusting guide in the
direction of the black arrow ( ).
Fix each stopper at the center groove
of 3 grooves.
Yes
Adjusting guide
Screw
Spring
MP unit
Stoppers
Spring
Adjusting guide
Screw
To Next Page
Loading...
