2KN/2KP
1-5-33
10. Remove the mirror 1 frame from the scanner
unit, passing the lever of mirror 1 frame rear
through the hole of the scanner unit rear
frame.
Figure 1-5-69
11. Remove the round terminals of the scanner
wire in the scanner unit left side from the
scanner wire spring.
12. Remove the scanner wires from the scanner
unit.
Figure 1-5-70
(2-2)Fitting the scanner wires
Caution
When fitting the wires, be sure to use those specified below.
Machine front: (P/N: 2FB1224), gray
Machine rear: (P/N: 2FB1225), black
Fitting requires the following tools
Frame securing tools: (P/N: 302FB68290)
Scanner wire stoppers: (P/N: 3596811)
Procedure
1. Move the mirror 2 frame as shown in the fig-
ure and insert two frame securing tools into
the positioning holes at the front and rear of
the machine center to fix the mirror 2 frame
in position.
2. Fit the frame securing tools using each two
screws.
Figure 1-5-71
Lever
Mirror 1 frame
Hole
Round terminals
Scanner wire springs
Mirror 2 frame
Frame securing tools
To Next Page
Loading...
