2KN/2KP
2-3-37
Connector Pin No. Signal I/O Voltage Description
YC1 1 24V I 24 V DC 24 V DC power input
Connected
to the DC
power
source PWB
2 PGND - - Power ground
3 SGND - - Signal ground
4 5V I 5 V DC 5 V DC power input
YC2 A1 CONT SENS O Analog Toner container sensor detection signal
Connected
to the
engine PWB
A2 MP TRY SW O 0/5 V DC MP tray switch: On/off
A3 MP PSD SW O 0/5 V DC MP paper length size switch: On/off
A4 MP PE SW O 0/5 V DC MP paper empty switch: On/off
A5 MP SOL RTN I 0/24 V DC MP solenoid (return): On/off
A6 MP SOL PUL I 0/24 V DC MP solenoid (activate): On/off
A7 FEED B SW O 0/5 V DC Feed switch 2: On/off
A8 DK SEL(I) I 0/5 V DC Deck PWB SEL signal
A9 DK RDY(O) O 0/5 V DC Deck PWB ready signal
A10 DK SCLK(I) I 0/5 V DC (pulse) Deck PWB clock signal
A11 DK SDO I 0/5 V DC (pulse) Deck PWB serial communication signal
A12 DK SDI O 0/5 V DC (pulse) Deck PWB serial communication signal
A13 SGND - - Signal ground
B1 CONT SET SW O 0/5 V DC Toner container detection switch: On/off
B2 MP DIG0 O 0/5 V DC MP paper width size switch: On/off
B3 MP DIG1 O 0/5 V DC MP paper width size switch: On/off
B4 MP DIG2 O 0/5 V DC MP paper width size switch: On/off
B5 MP MOT CLK I 0/5 V DC (pulse) MP feed motor clock signal
B6 MP MOT REM I 0/5 V DC MP feed motor: On/off
B7 MP MOT HLD I 0/5 V DC MP feed motor hold signal
B8 MP MOT
MODE
I 0/5 V DC MP feed motor mode signal
B9 MP MOT CW I 0/5 V DC MP feed motor CWB signal
B10 MAIN MOT
REM
I 0/24 V DC Drive motor: On/off
B11 MAIN MOT
ALM
O 0/5 V DC Drive motor alarm signal
B12 N.C - - Not used
B13 SGND - - Signal ground
To Next Page
Loading...
