2KN/2KP
1-3-24
U063
Adjusting the shading position
Description
Changes the shading position of the scanner.
Purpose
Used when the white line continue to appear longitudinally on the image after the shading plate is cleaned.
This is due to flaws or stains inside the shading plate. To prevent this problem, the shading position should be
changed so that shading is possible without being affected by the flaws or stains.
Method
1. Press the start key. The setting screen is displayed.
2. Change the setting value using the cursor up/down keys.
Increasing the value moves the shading position toward the machine right, and decreasing it moves the
position toward the machine left.
3. Press the start key. The value is set.
Supplement
While this maintenance item is being executed, copying from an original is available in the interrupt copying
mode.
Completion
Press the stop/clear key at the screen for adjustment. The screen for selecting a maintenance item No. is dis-
played.
U064
Adjusting the CCD level
Description
Adjusts the CCD level.
Purpose
To adjust when density difference due to CCD is generated between both sides of the center of the copy
image.
Setting
1. Press the start key. The screen for adjustment is displayed.
2. Change the setting using the cursor up/down keys.
3. Press the start key. The value is set.
Supplement
While this maintenance item is being executed, copying from an original is available in the interrupt copying
mode.
Completion
Press the stop/clear key at the screen for adjustment. The screen for selecting a maintenance item No. is dis-
played.
Maintenance
item No.
Description
Setting item Setting
range
Initial setting Change in value per step
Shading position -8 to 2 0 0.17 mm
Description Setting range Initial setting
CCD level 3 to 5 4
To Next Page
Loading...
