OBD & Battery Analysis Scanner
- 1 -
Important Safety Information
To prevent personal injury or damage to vehicles and/or the
Scan Tool, read this
instruction manual first and observe the following safety precautions, at a minimum,
whenever working on a vehicle:
1.
Always perform automotive testing in a safe environment.
2.
Wear safety eye protection.
3.
Keep clothing, hair, hands, tools, test equipment, etc. away from all moving or hot
engine parts.
4.
Operate the vehicle in a well ventilated work area. Exhaust gases are poisonous.
5.
Put blocks in front of the drive wheels and never leave the vehicle unattended while
running tests.
6.
Use extreme caution when working around the ignition coil, distributor cap, ignition
wires and spark plugs. These components create hazardous voltages when the engine
is running.
7.
Put the transmission in PARK (for automatic transmission) or NEUTRAL (for manual
transmission) and make sure the parking brake is engaged.
8.
Keep a fire extinguisher suitable for gasoline/ chemical/ electrical fires nearby.
9.
Don't connect or disconnect any test equipment while the ignition is on or the engine
is running.
10.
Keep the Scan Tool dry, clean, free from oil, water or grease. Use a mild detergent on
a clean cloth to clean the outside of the Scan Tool, when necessary.
Specifications
Service
There are no user serviceable parts. Scan Tool service must be performed only by qualified
repair personnel.
8V to 30V power provided by vehicle battery
To Next Page
Loading...