Kzyee KM301 - Reading Trouble Codes; Selecting Code Types for Reading; Viewing DTC Information

OBD & Battery Analysis Scanner
- 28 -
Read Trouble Codes
Modes $03, $07 and $0A Request Emission-Related DTCs
1. From Diagnostic Menu, usethe
Up/ Down button toselect
Read Codes, then press OK.
Read Codes
1. From Read Codes, select from:
a. Stored Codes - Mode $03
b. Pending Codes - Mode $07
c. Permanent Codes - Mode $0A
This mode is available on
some vehicles starting in
2010 and is required on all
2012 and newer vehicles.
2. If there are no DTCs, the
message “No codes are stored
in the module” will appear.
Figure 68
3. View the DTC.
DTC Control Module
P0122
2/8
$10 Generic
Throttle / Pedal Position
Sensor / Switch A Circuit Low
DTC Description
Figure 69
4. See “DTC Lookup” on page 29
to view likely causes for DTCs.
Note: To view operational data stored when
the DTC was stored, see
View Freeze Frame Data on page 37.
Diagnostic Menu 1/11
Read Codes
Erase Codes
Live Data ?
View Freeze
Frame I/M
Readiness
02 Monitor Test
On-Board Mon. Test