Kzyee KM301 - Component Test Function; Executing Component Tests; Viewing Component Test Results

OBD & Battery Analysis Scanner
- 40 -
Component Test
Mode $08 - Request Control of On-Board
System, Test or Component
Command the PCM to run an
Evaporative Leak Test.
This section contains advanced
functions. Some data may need to be
interpreted by a qualified technician.
Note: Not all vehicles return the same
data, results may vary from the examples
given herein.
1. From Diagnostic Menu, use theUp/
Down button to select Component
Test, then press OK.
If the vehicle responds, a confirmation
message will be displayed.
Figure 116
2. View test module.
Figure 114
If the vehicle does not allow the test, an
advisory message will be displayed.
Figure 117
3. Press OK for test results.
Component Test
The selected mode is
not supported
Press any key to con.
Figure 115
Figure 118
Note: If necessary, have a qualified
technician Interpret the data.
Component Test
Command Sent!
Press any key to con.
Diagnostic Menu 8/11
Component Test
Vehicle Info.
Modules Present
Unit of Measure
$81 Test
TEST 00:00:18
MIN 00:00:00
MAX 00:01:05
STS OK
EVAP Monitor(0.090) 1/1
$81 Test