L-Acoustics A15 Series User Manual

Rigging procedures
Adding a pullback with A15-BUMP/A15-RIGBAR
Type of deployment own array with pullback
A15-BUMP/A15-RIGBARRigging accessory
1 x Ø12 mm shackle WLL 1 t (provided)
Min number of operators 2
Risk of falling objects
Verify that no unattached items remain on the product or assembly.
Assembly
Procedure
1. Prepare a vertical array as described in Flying a vertical array with A15-BUMP/A15-RIGBAR (p.49).
2. Raise the array until the bottom enclosure is accessible.
3. Secure A15-BUMP or A15-RIGBAR under the array.
A15-BUMP A15-RIGBAR
Connect A15-BUMP to the bottom enclosure on both
sides.
Connect A15-RIGBAR to the bottom enclosure on both
sides.
SHLAK!
SHLAK!
56 A15 owner's manual (EN) version 1.2

L-Acoustics A15 Series Specifications

General

Nominal impedance	8 ohms
Frequency Response	44 Hz - 20 kHz
Maximum SPL	141 dB
Amplification	LA4X / LA8 / LA12X
Weight	33 kg
LF Transducers	1 x 15'' neodymium
HF Transducers	1 x 3'' diaphragm compression driver
Power Handling	800 W
Connectors	2 x 4-point speakON