8. To select an Ingredient to be displayed or programmed, press the Ingr. key or Ingr.
and e keys. To select the Names of Ingredients backwards, press the Block and
Ingr. keys. The Name and the programmed weight will appear alternately on the
display. If no name has been assigned to the Ingredient, the [
ING
x
] message will
appear on the display, where x indicates the progressive number of the Ingredient
selected.
9. To program the Name of the Ingredient (max. 6 alphanumeric characters) press the
2FN key for 2 seconds and use the Alphanumeric Writing. If the Name is being used
in another Recipe, instead of entering the Name using the alphanumeric keys, inside
the Alphanumeric Writing it is possible to select the Name from the Ingredient/
Unload Name Archive, pressing the q z (e) keys. After selecting the Name, press
the OK key to confirm.
r Important: when a new Name is created, the Name is automatically memorized in
the Ingredient/Unload Name Archive. r
10. To program the weight value, use the q z (e) keys or the Alphanumeric Writing (2FN).
r Important: if the 2FN key is pressed for more than 2 seconds, the equipment will
automatically select the procedure Ingredient/Unload Name Programming
(see par. 9). r
r Important: if the current Recipe is a Daily Recipe, the weights must be
programmed by the total value of the daily ration (morning and afternoon). r
11. If the user wishes to program an Ingredient as a Manual Addition, select the
Ingredient and press the OK key for 4 seconds. The g will appear next to the
symbol and the message [
HAND. AD.
] will appear. Release the key when the
Name and the programmed weight appear alternately on the display. To delete the
Manual Addition from the Ingredient, repeat the same procedure.
12. If the user wishes to modify the type of Skip to the Next Ingredient/Unload compared
to the one automatically set with the relative Function (see chapter 4.13.1), select
the Ingredient that you wish to change and press the Block key for 2 seconds. The
change is accompanied by the switching on (Manual skip) or switching off (Automatic
skip) of the m symbol on the display.
13. To select another Ingredient, repeat the procedure from point 8.
14. To delete the selected Ingredient (Name, weight and parameters) from the Recipe,
press the Clear key for 4 seconds. The [
DELETE
] message and the selected Name
will appear alternately on the display.
user’s guide20
To Next Page
Loading...
Need help?
General