Error Displayed in When
[
ERR- 1
]
• Recipe Execution Activity
• Manual Weighing Activity
• Weighing Activity with Threshold
• No-Load Tare Function
• Power Voltage Control Function
• Diagnostic Tests
• Calibration Procedure
• The A/D Converter is over the Full Scale value.
Refer to Appendix D - Troubleshooting or contact Customer Service for further information.
[
ERR- 5
]
• Recipe Programming Activity • The selected Recipe is empty.
[
ERR- 8
]
• Recipe Programming Activity • The weight of at least one Ingredient/Unload of the Recipe is greater than 30,000 kg/lbs
(Recipes by Totals) or 300.00 kg/lbs (Recipes by Animal Number).
• The weight of at least one Ingredient/Unload of the Recipe is greater than 100%.
[
ERR- 9
]
• Recipe Programming Activity • In a Recipe by Animal Number the sum of the programmed percentages is not 100%.
[
ERR-11
]
• Recipe Programming Activity • In a Recipe by Totals the user attempts to modify the Total Single Animal (DMI).
• In a Recipe programmed by Animal Number or as percentage value the user attempts to select
the Modify Total Recipe Weight Function.
[
ERR-12
]
• Recipe Programming Activity • The value of at least one Ingredient memorized in the Usage by Ingredient Function is greater
than 900,000 kg/lbs or the value of at least one Unload memorized in the Unloads by Pen
Function is greater than 900,000 kg/lbs. To eliminate the error, reset to zero (see chapters
4.13.3 or 4.13.4 of the User’s Guide).
To continue the operation without resetting, press the OK key. The Ingredient/Unload totalizator
with a value greater than 900,000 kg/lbs will be not updated.
To exit and return to the Recipe Programming Activity, press the Prog./Start key.
• Usage by Ingredient Function
• Unloads by Pen Function
• The totalizator has exceeded the maximum value (900,000 kg/lbs).
To eliminate the error, reset to zero. (see chapters 4.13.3 or 4.13.4 of the User’s Guide).
user’s guide72
To Next Page
Loading...
Need help?
General