[
ERR-13
]
• Recipe Programming Activity • The printer is turned off or is not connected to the equipment.
To eliminate the error, turn on or connect the printer and press the OK key.
• Data Transfer Function with the
T-Data8 Plug
• The T-Data8 Plug device was disconnected during the data transfer or is broken.
Apply to the Customer Service for further Information.
[
ERR-15
]
• Manual Weighing Activity • The Weight Block Function is not allowed because the Total Weight is displayed.
The Function is only allowed during the displaying of the Partial Weight.
[
ERR-16
]
• Recipe Execution Activity • The No-Load Tare Function is not allowed.
The Function is only allowed in the Recipe Programming Activity and in the Manual Weighing
Activity.
[
ERR-17
]
• Switching-On • For further information see the Technical Guide.
[
ERR-19
]
• Data Transfer with T-Data8 Plug • The control checksum of the transmitted data is incorrect.
To eliminate the error, press the OK key and repeat the Procedure.
[
ERR-20
]
• Transfer of Wireless Data • The data received from or sent by the PC is incorrect.
To eliminate the error, press the OK key and repeat the transmission of data.
If the PC transmits the Data once again, the equipment will automatically prepares for
connection. If the error occurs again, try to decrease the distance between the equipment and
the Label USB Wireless Linker device.
[
ERR-21
]
• Recipe Execution Activity
• Data Transfer with T-Data8 Plug
• Transfer of Wireless Data
• Print Mixing Report Function
• The 3000 Weighing Operations File is full.
To eliminate the error, download the data using the T-Data8 Plug device or with the Wireless
Data Transfer Function or delete the 3000 Weighing Operations File with the Procedure
described in the Mixtures Report Function. Another method for deleting the 3000 Weighing
Operations File is to disable the Data Transfer and printing in the relative Preference (code 71).
[
ERR-22
]
• Diagnostic Tests • A malfunction of the Printer Serial Line or the RF/PC/GSM Serial Line has been detected.
To eliminate the error condition, check the link of the connectors.
Contact Customer Service for further Information.
[
ERR-23
]
• All Activities • The printer is turned off or disconnected.
AppeNdiX A 73
To Next Page
Loading...
Need help?
General