LaCie Ethernet Disk - 14 Restoring Your Ethernet Disk Using the Lacie Restore CD

LaCie Ethernet Disk Restoring Your LaCie Ethernet Disk
User Manual page 56
In the event that LaCie Technical Support asks you to restore
your Ethernet Disk from CD please use the steps outlined below.
IMPORTANT INFO: Restoring will erase all data from the Eth-
ernet Disk; therefore whenever possible backup your data before
restoring from CD.
1. Whenever possible first back up the data from the Ethernet
Disk, and note down what version of Ethernet Disk software
you are using.
2. Connect a monitor to the VGA video port (see section 2.4.
Rear Panel), a mouse to either the mouse port (Windows) or
one of the Hi-Speed USB 2.0 ports, and optionally a key-
board to either the keyboard port (Windows) or one of the
Hi-Speed USB 2.0 ports on the back of the Ethernet Disk.
3. Connect an external USB CD-ROM drive to one of the Hi-
Speed USB 2.0 ports of the Ethernet Disk.
4. Insert the “Restore CD” and restart the Ethernet Disk.
5. Check that the system is booting from the CD (Fig. 74).
TECHNICAL NOTE: If the Ethernet Disk does not boot from the
USB CD-ROM drive, Edit the BIOS configuration by pressing the
“Del” button at startup and make sure that the “First Boot Device”
option is set to “USB-CDROM” in the menu “Advanced BIOS Fea-
tures”.
14. Restoring Your Ethernet Disk Using the LaCie Restore CD
Fig. 74