Configuring the Unit
4.4 Configuring via the Setup Mode Window
4.4.1 Using a Telnet Connection
To configure the unit over the network, establish a Telnet connection to port 9999.
Note: If you use the Telnet icon on the XPort™ Installer toolbar OR a serial port login to
establish the connection, skip steps 1and 2.
1. From the Windows Start menu, click Run and type the following command, where x.x.x.x
is the IP address and 9999 is the unit’s fixed network configuration port number.
telnet x.x.x.x 9999
Note: Be sure to include a space between the IP address and 9999.
2. Click OK.
3. The Setup Mode window displays.
MAC address 00204A4113A3
Software version 01.0b9 (021219) XPT
Press Enter to go into Setup Mode
4. To enter the Setup Mode, you must press Enter within 5 seconds. The configuration
settings will appear.
5. Select an option on the menu by entering the number of the option in the Your choice ?
field and pressing Enter.
6. To enter a value for a parameter, type the value and press Enter, or to confirm a current
value, just press Enter.
7. When you are finished, save the new configurations (option 9). The unit will reboot.
XPort™ User Manual and Development Kit 4-7
To Next Page
Loading...
Need help?
General