Lantronix XPort User Manual

Monitor Mode
Table 22 - Monitor Mode Commands
Command Command Name Function
VS x.x.x.x Version Query software header record (16 bytes) of
Device Server with IP address x.x.x.x
GC x.x.x.x Get Configuration Get configuration of Device Server with IP
address x.x.x.x as hex records (120 bytes)
SC x.x.x.x Send Configuration Set configuration of Device Server with IP address
x.x.x.x from hex records
PI x.x.x.x Ping Ping Device Server with IP address x.x.x.x to
check device status
AT ARP Table Show the Device Server’s ARP table entries
TT TCP Connection
Table
Shows all incoming and outgoing TCP
connections
NC Network Connection Shows the Device Server’s IP configuration
RS Reset Resets the Device Server’s power
QU Quit Exit diagnostics mode
G0, G1, ....,Ge,
Gf
Get configuration
from memory page
Gets a memory page of configuration information
from the device.
S0, S1,...,Se, Sf Set configuration to
memory page
Sets a memory page of configuration information
on the device.
Responses to some of the commands are given in Intel Hex format (see The Intel Hex
Format on page 9-4).
Note: Entering any of the commands listed above will generate one of the following
command response codes:
Table 23 -Command Response Codes
Response Meaning
0> OK; no error
1> No answer from remote device
2> Cannot reach remote device or no
answer
8> Wrong parameter(s)
9> Invalid command
XPort™ User Manual and Development Kit 8-3

Lantronix XPort Specifications

General

Data Link Protocol	Ethernet, Fast Ethernet
Connectivity Technology	Wired
Form Factor	Embedded
Category	Embedded Systems
Interface	Serial
Serial Ports	1
Operating Temperature	0°C to 70°C