Configuring the Unit
The configurable pins can be set to A = active, I = Inactive, or X = Don’t Care. Active can
mean Active Low or Active High. The configurable pins’ setting can only be changed using
XPort™ Installer.
Message : Enter the subject line of the e-mail.
Priority: L is for normal priority, H is for High Priority.
Min. notification interval: The minimum time allowed between individual triggers. If a trigger
event occurs faster than the minimum interval, the trigger will be ignored.
Re-notification interval : If a single trigger event stays asserted, then an e-mail message will
be sent at this time interval.
Each trigger is independent from the others. Each condition within an individual trigger must
be met before the e-mail will be sent.
4.8 Expert Settings
Note: You can change these settings via Telnet or serial connections only, not on the Web-
Manager.
These parameters should only be changed if you are an expert
and definitely know the consequences the changes might have.
TCP Keepalive time in s (1s – 65s; 0s=disable): (0)
ARP Cache timeout in s (1s – 600s) : (600) ?
4.8.1 TCP Keepalive time in seconds
This option allows you to change how many seconds the unit will wait during a silent
connection before attempting to see if the currently connected network device is still on the
network. If the unit then gets no response, it will drop that connection.
4.8.2 ARP Cache timeout in seconds
Whenever the unit communicates with another device on the network, it will add an entry
into its ARP table. The ARP Cache timeout option allows you to define how many seconds
(1-600) the unit will wait before timing out this table.
4-24 XPort™ User Manual and Development Kit
To Next Page
Loading...
Need help?
General
