Lantronix XPort User Manual

Using XPort™Installer
6.10 Device Configuration Reference
Device configuration information is stored in flash memory and is read and displayed in the
properties section on the right side of the XPort™ Installer window. This section describes
some of those options in detail.
6.10.1 E-mail Notification
E-mail notification setup can be done via Telnet, serial port, or XPort™ Installer. See E-mail
Settings on page 4-22 for additional information and other methods of e-mail setup.
Domain Name: Domain name of your e-mail server. Example: Lantronix.com
MailServer: The IP address of the mail server.
Recipients: E-mail addresses of the recipients. See
E-mail Recipients Collection on page 6-11.
Triggers: Events that trigger an e-mail. See E-mail Triggers Collection on page 6-11.
Unit Name: Name used by the XPort™ to send e-mail messages. This name and the
Domain Name are combined to give you the e-mail address of the sender. For example, if
the Unit Name is XPort and the Domain Name is Lantronix.com, then the e-mail sender
name would be XPort@lantronix.com
To configure e-mail properly, you will need to make entries in the e-mail recipients collection,
the e-mail triggers collection, Domain Name, Mail Server, and the Network (see Network on
page 6-13).
6-10 XPort™ User Manual and Development Kit

Lantronix XPort Specifications

General

Brand	Lantronix
Model	XPort
Category	Server
Language	English