*Remarks: CH1 and CH2 output voltage at the same time, and the sum of output
voltage is 5V. If the voltage of CH1 or CH2 is adjusted separately, the other channel will
be linked.
5)
Accelerator pedal position sensor
Output channel: CH1, CH2 (changes on either of the two channels will cause
the other channel to output the corresponding signal)
Output type: DC voltage
Drag the yellow slider to change the output voltage value of CH1.
Drag the green slider to change the output voltage value of CH2.
*Remarks: CH1 and CH2 output voltage at the same time, and the ratio of CH1 output
voltage to CH2 output voltage is 2:1. If the voltage of CH1 or CH2 is adjusted separately,
the other channel will be linked.
www.diagtools.eu, Pernavas 43A, Riga, Latvia, LV-1009, +37129416069, info@diagtools.eu
To Next Page
Loading...
