Manual Leapfrog Creatr
38 Leapfrog BV
Select your desired print settings (1).
For an explanation of the printing settings, look at the next chapter Print settings.
Select single or dual extruder under printer settings (2) depending on what you own. NB: for a
single extruder print with a dual extruder Creatr you will need to select a dual extruder.
Choose your type of filament (3) It is possible to print your design in ABS, PLA or PVA.
If you are printing your design in ABS and your support in soluble PLA or PVA, always position
your support material in the right extruder!
Slice your STL file by clicking the Slice with Slic3r” button.
To Next Page
Loading...