Service Manual JET3
16 Rev. 1.0
Extract of declaration of conformity
according to machinery directive (2006/42/EG), Appendix II 1.A
according to low-voltage directive (2006/95/EG)
according to EMC directive (2004/108/EG)
complies with the provisions of the above mentioned directives –including the changes which
valid at that time of the declaration. The following harmonized standards have been applied:
Safety of machinery – General principles for design – Risk
assessment and risk reduction
Information technology equipment – Safety;
part 1: General requirements
Ergonomics for the thermal environment – Methods for the
assessment of human responses to contact with surfaces;
part 1: Hot surfaces
Electromagnetic compatibility (EMC) – part 6-2:
Generic standards – Immunity for industrial environments
Electromagnetic compatibility (EMC) – part 6-3:
Generic standards – Emission standard for residential,
commercial and light-industrial environments
For that product the relevant technical documentation were compiled according to Annex VII
part A of the machinery directive, on a resend request this documents can be transmitted to
national authorities per CD.
Name and address of the person who is authorised to arrange the technical documentation:
Volker Teufel, authorised documentation agent,
Paul Leibinger GmbH & Co. KG, D-78532 Tuttlingen (Germany)
Annotation:
The device fulfills the fundamental health and safety requirements of the directive 94/9/EU,
but is intended only for use outside of explosive areas. This declaration is only valid for the
components which are included in the delivery range of the manufacturer. The installation
and works which have been carried out by the customer either the distributor as well as it's
components and modules are not the responsibility of the manufacturer. The adherence of
the valid standards and regulations of the technology are generally the responsibility of the
customer either of the distributor.
To Next Page
Loading...
