Leibinger JET3 up - Exchange Head Motor (SK6)

Service Manual JET3
Rev. 1.0 117
6) Exchange head motor
Necessary Tools:
1,5mm hex key, 2,0mm hex key, tweezers, flat screwdriver 2,5mm
1. Switch on the JET3up and wait until initialization is finished.
2. Touch the softkey <Hydraulic settings> (1), go in the menu <Hydraulic/Printhead>
and switch to tab <Printhead> (2). Press the button <Ink off> (3).
1 – Softkey <Hydraulik settings>
2 – Menu <Printhead>
3 – Button <Ink off>

1
2
3