Leibinger JET3 up - Removing and Cleaning the Nozzle (SK6)

Service Manual JET3
Rev. 1.0 105
3) Removing and cleaning the nozzle
Necessary tools: sixfold magnifier, 2mm hex key.
1. Switch on the JET3up and wait till the “bleeding cycle” of the system is finished.
2. Click on the softkey <Hydraulic settings> (1) to change to the menu <Printhead> (2).
Press the button <Ink off> (3).
1 – Softkey <Hydraulik settings>
2 – Menu <Printhead>
3 – Button <Ink off>

3
2
1