Leibinger JET3 up - Service Works; Service TAG Activation Procedure

Service Manual JET3
56 Rev. 1.0
7 Service works
7.1 Service TAG
In order to reset the counter for the service interval you must activate a service TAG.
The Tag is located invisible below the label of the main filter.
Important Notice:
The TAG is glued together with the label to the main filter.
Do not try to remove the TAG from the main filter!
This may destroy the TAG!
It is necessary to activate the TAG before you change the main
filter. After the installation, you cannot access the TAG anymore.
Main filter with label
Procedure:
1. Hold the main filter with the label in front of the TAG reader.
The dialog box <TAG Reader Results> pops up.
Open the service interval dialog box with the
TAG
2. Enter the data for the next service interval. The interval is set in months (3) and operating
hours (2). Service will be due after the period or operating hours set, whichever occurs first.
3. Reset the <Working hours since last service> with the button <Reset> (1).
TAG activation
1 – Button <Reset>
2 – Input field <Service Intervall> Hours
3 – Input field <Service Interval> Month
4 – Button <Activate>
4. After setting the desired values confirm with the button <Activate> (4).
3
2
2
1
4