Leibinger JET3 up - Change the Controller Board

Service Manual JET3
186 Rev. 1.0
Change the controller board with the following steps:
Necessary tools:
- Special assembly tool: Art. Nr.: 55-006824 K
- Face pin wrench Art. Nr.: 54-003526 K
1. Switch off the JET3up.
2. Remove the main plug.
Dangerous electrical voltage!
Contact causes serious injuries through an electric shock! Disconnect the device
from the voltage supply by remove the main plug before you open the electronic
cabinet!
Special assembly tool
Face pin wrench
Switch off the JET3up