EasyManua.ls Logo

Leibinger JET3 up - Accidental Release (Spillage) Procedures

Leibinger JET3 up
214 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Service Manual JET3
Rev. 1.0 19
3.4 Measures in the event of accidental release (spillage)
PRECAUTIONARY
MEASURES
Switch off sources of ignition and ventilate room. Keep personnel
that is not absolutely necessary away. Do not inhale any vapour.
Observe the protective measures listed.
ENVIRONMENTAL
PROTECTION
MEASURES
DO NOT allow to enter waste water channels or waters.
Should the product enter waste water channels or the drainage
system the local water supply authority must be informed
immediately. In the event of contamination of streams, rivers or
lakes inform the national water authorities. Vapour is heavier than
air and can spread out on the ground. In combination with air it can
form an explosive mixture.
RESTORATION
Restrict and suck up spilled substances with a non-combustible
absorbent material (e.g. sand, earth, vermiculite, infusorial earth)
and collect in a suitable container for removal. Preferably clean
areas with spilled substances with a detergent. Avoid solvents.

Table of Contents

Other manuals for Leibinger JET3 up

Related product manuals