Leibinger JET3 up - Page 210

Service Manual JET3
210 Rev. 1.0
5. For a successful activation, it is necessary that you hold the “Service TAG” on the TAG
reader during the whole activation process. Otherwise you will get the error message:
“TAG activation failed”.
After a successful activation the new service intervals are saved and the following
message is displayed:
TAG activation
Close the dialog box with the button
<Quit>.
Close the confirmation prompt with the
button <Quit>.
INFORMATION
- For a successful activation you must use a valid TAG.
- You can use a Tag for a successful activation only one time.
- Don`t remove the TAG during the activation process.
Otherwise the TAG could be damaged.
- With an invalid TAG you can open the service interval dialog
box but you can`t save any values.