Leica mojo3D, Automatic Section Control 149
Metric calculation Latency [s] = Distance travelled [m] ÷ Speed [km/h] x 3.6
Example
Assuming that the operator was travelling at 20 km/h and the distance from the rope
to where the application reacted is 5 m:
5 m ÷ 20 km/h x 3.6 = 0.9 seconds Latency
2. Drive over the previous run at a right
angle, with the master on. Ensure
that there is enough distance before
crossing over the marked line for any
implements to straighten up behind
the vehicle.
3. Measure the distance from the rope
to where the application actually
reacted.
a) Turn On delay
b) Turn Off delay
To Next Page
Loading...
