Leica mojo 3D - Calibrating the Section Control Latency Value

148
Leica mojo3D, Automatic Section Control
7.1.1 Calibrating the Section Control Latency Value

For the purpose of this calibration exercise, if using a boom spray, the tank should
contain only water.
Calibrating latency,
step-by-step
To calibrate the section control latency value, carry out the following steps:
1. Drive slowly in a straight line for
200 m (650 ft) with the master on.
Half way along the run, mark on the
ground where the end of the imple-
ment passes with two pegs and a
rope.