Leica mojo3D, mojo3D Enhancements 313
A.2 mojo3D with Multi Section Control Kit
General informa-
tion
• Multi section control is available as an option for the mojo3D.
• The multi section control kit uses the Leica AS400 section controller to provide
multi section control. This option allows for multiple individual sections to be
automatically controlled, in order to minimise overlap. Leica AS400 provides up
to 13 section control.
• The interface for this control is a simple voltage control, which allows the multi
section control kit to be used with a wide range of third party rate controllers.
• The interface provides a master input sense from a single or dipole switch.
Direct Section Control Kits are also available. For Further Information see
your Leica Geosystems Dealer or refer to www.virtualwrench.com
Accessories
required
• mojo3D Port Expansion Cable
• Multi Section Control Kit or Direct Section Control Kit
To Next Page
Loading...
