Leica mojo 3D - Upgrading Software from Virtual Wrench

236
Leica mojo3D, Virtual Wrench™ Remote Service
12.3 Upgrading Software from Virtual Wrench™
General informa-
tion
A new version of software, if available, may be obtained by downloading from Virtual
Wrench™.

Caution Do not turn off the mojo3D while the software upgrade is under way.
Downloading soft-
ware, step-by-step
To download a new version of software from Virtual Wrench™, carry out the
following steps:
1. On the main navigation screen, tap the service button.
2. On the flyout menu, tap the download software button.
3. If you are not already connected to Virtual Wrench a dialog confirming connection
will be displayed:
• tap to proceed.
OR
tap to abandon the request.